Used phone shows "No Service" or "SIM Not Supported": what it means and what to do
Published
You put your SIM card into a phone you just bought and it shows No Service, SOS only or a SIM Not Supported message. It is tempting to assume the worst, but there are five common causes, and a few minutes of testing usually tells you which one it is.
Read the exact message
The wording matters. "SIM Not Supported" or "SIM Not Valid" on an iPhone almost always means the phone is carrier locked to a different network. "No Service" or "SOS only" with no lock message points to a blocked IMEI, an inactive SIM, a network setting or a hardware fault. Android phones that are carrier locked usually ask for a "SIM network unlock PIN".
Cause 1: carrier lock
The phone accepts only SIM cards from the carrier it was sold for. Test with a SIM from that carrier if you can: if it works, the phone is locked. An IMEI check of the activation policy confirms which carrier and whether the lock is still in place. Only that carrier can remove it, usually once the phone is paid off.
Cause 2: blacklisted IMEI
If the IMEI was reported lost or stolen, networks that read the GSMA list refuse to register it. The phone shows No Service with every SIM, while Wi-Fi works normally. A GSMA blacklist check shows the status and the date it was listed. Only the carrier that listed it can remove it; if you have just bought the phone, contact the seller and the platform you bought it on.
Cause 3: the SIM or the line itself
Try your SIM in another phone. If it fails there too, the SIM or the line is the problem: the line may be suspended, the SIM damaged, or a new SIM not yet activated. Carriers that lock a SIM to its original IMEI may also need you to register the new device.
Cause 4: eSIM and network settings
If your plan is on eSIM, a physical SIM swap does nothing: the eSIM has to be transferred to the new phone through the carrier or the phone's setup screen. Also check that the phone supports your carrier's frequency bands, that mobile data and roaming are set correctly, and that the software is up to date; an iPhone may also need a carrier settings update in Settings > General > About.
Cause 5: hardware
If the phone works with no SIM at all, Settings shows no IMEI, or the IMEI shown by *#06# is missing or all zeros, the cellular hardware may be damaged, often after a drop, water damage or a poor board repair. That is a repair-shop job and a strong reason to return the phone.
The quick decision tree
- SIM Not Supported, original carrier's SIM works: carrier lock.
- No Service with every SIM, Wi-Fi fine, IMEI shows normally: likely blacklist. Run a GSMA check.
- Your SIM fails in other phones too: SIM or line problem. Call your carrier.
- No IMEI shown, or no SIM detected at all: hardware fault.
Check a device
Find out in seconds whether the phone is carrier locked or blacklisted.